Battery Technologies

Engineered cell architecture, built for standby duty

UFEND cells pair a proprietary lead-alloy grid formulation with a pure gel electrolyte system. Each design begins from the operating requirement, whether that is float service, deep cycling, or high-rate discharge.

Internal cell architecture follows a single principle: stable plate geometry, controlled electrolyte distribution, and sealed construction that holds performance across the service life of the product.

Manufacturing

From plate grid to finished cell

01

Grid casting

Lead-alloy grids are cast to a defined geometry so that every plate starts from a consistent metallurgical base.

02

Paste and curing

Active material is applied and cured under controlled humidity and temperature, setting plate density for each product family.

03

Formation

Plates are formed in a controlled charge cycle that establishes the active chemistry before assembly.

04

Assembly and gel filling

Plates are assembled into the cell and filled with pure gel electrolyte through an automated system that monitors each fill.

Quality Control

Inspection at every stage

In-line checks and laboratory testing follow standardized industrial protocols. Certification scope and test reports are supplied on request for each product family.

In-line automated testing

Plate formation, internal impedance, and seal integrity are measured during production, so deviations are caught before a cell moves on.

Battery testing

Laboratory procedures verify capacity, float behaviour, and discharge performance against the specification for each product line.

Certifications

Compliance with international industrial testing protocols is documented per product. Request the relevant certificate and test records for your project.